KitchenAid stand mixer repair in King City
I cover King City with pick up and drop off for $20. Your mixer is collected from your door and comes back repaired and test run.
Where two prices are shown, the first is for tilt-head mixers (Artisan, Classic, Ultra Power) and the second for bowl-lift mixers (Professional 600, Pro 5 Plus, Pro Line), which take longer to strip down and rebuild.
- Re-grease and gasket replacementThe most common KitchenAid fault I see. Old grease breaks down, the gasket hardens, and oil starts weeping out under the base and into the bowl.
$100 any mixer
- Re-grease, gasket and worm gear replacementBest valueThe most complete service I do: a new worm gear, a new gasket and a full re-grease in one visit. Doing everything at once means one strip-down and costs less than booking repairs separately.
$150 tilt-head
$175 bowl-lift
- Power cord replacementA worn power cord is a safety problem, not just an annoyance. I replace the cord and the strain relief so the lead is properly anchored again.
$70 tilt-head
$95 bowl-lift
- Speed controller replacementWhen the mixer only runs flat out, ignores the speed dial, or will not switch off, the speed controller has failed.
$125 tilt-head
$150 bowl-lift
- DiagnosticsFor mixers that do not match any of the symptoms above. I find the fault, tell you what it needs and what it will cost, and you decide from there.
$40 any mixer
Applied towards any repair
Pick up and drop off across Vaughan, Kleinburg and King City: $20. Drop it off yourself: free.
Every repair is test run before it comes back, and covered for 90 days on the parts replaced and the work done.
KitchenAid stand mixers are all I repair. An oil leak, a grinding gearbox or a mixer stuck on one speed are jobs I do every week, and each costs far less to fix than the mixer costs to replace.
Tell me what the mixer is doing, we agree a time, and the price is confirmed before any work starts. If you are passing through Vaughan anyway, you can drop it off with me for free.
Older mixers are welcome. A KitchenAid that has been in the family for decades is usually worth repairing, and if yours is not, I will tell you so before you spend anything beyond the diagnostic fee.
Nearby: Vaughan, Maple, Kleinburg, Nobleton. If you are close by but not listed, ask and I will tell you honestly whether pick up works. Drop-offs are welcome from anywhere.
Got a mixer that needs looking at?
Text me what it is doing. You will know the price before any work starts.