KitchenAid power cord replacement
A worn power cord is a safety problem, not just an annoyance. I replace the cord and the strain relief so the lead is properly anchored again.
Does this sound familiar?
- Fraying, nicks or exposed wire anywhere along the cord
- A cracked or hardened rubber boot where the cord enters the mixer
- The mixer cutting out or needing the cord wiggled to start
- A plug or cord that feels warm after use
What the repair includes
- Old cord removed and the entry point inspected
- New power cord fitted
- New strain relief so the cord is anchored and cannot pull on the internals
- Continuity and run test before the mixer comes back
The cord takes more abuse than any other part of a stand mixer. It gets wrapped, hung, pulled and yanked, and the point where it enters the mixer body is where the damage almost always starts.
Once the outer sheath cracks there, the inner conductors are exposed to the same flexing, and an intermittent connection or a short is not far behind. It is a genuine safety issue and one of the cheapest things on this list to put right.
I fit a new cord with proper strain relief so the repair lasts, rather than splicing a new plug onto a cord that is already failing.
Not sure this is your problem?
These guides explain the symptoms and what you can check yourself first.
Common questions
My mixer only starts if I wiggle the cord. Is that the cord?
It is the most likely cause and the cheapest thing to rule out first. Book the cord replacement or a diagnostic and I will confirm it before doing any work.
Related repairs
Re-grease and gasket replacement
$100 any mixer
Re-grease, gasket and worm gear replacement
$150 tilt-head · $175 bowl-lift
Speed controller replacement
$125 tilt-head · $150 bowl-lift
Got a mixer that needs looking at?
Text me what it is doing. You will know the price before any work starts.